No Service on iPhone 6, How to Fix?

When your iPhone says "No Service", your iPhone can' t make or receive phone calls, send messages, or connect internet, it will affect the life and work. And it' s easy to forget how integral our iPhones have become in our lives, until they don' t work. In this article, I’ll explain the reason of your iPhone says No Service and the solution of this issue.

The faulty is that there is no service on iPhone 6. It' s been repaired, but it' s not fixed. After we received the iPhone 6, we started checking the iPhone. We can't find the operator in manual condition. Disassemble the iPhone 6 by phone opening tool, take out the motherboard, we can found that the colleague has been repaired RF parts, now we need to fix it step by step. As shown in picture 1-1.

Let' s start with the easiest. Soldering jump wire on U1、V1 pin, still no service. Because the colleague repaired too many chips, as long as the chip on the RFFE bus has problems, it will affect this. Remove all chips except 2G power amplifier on RFFE bus, the iPhone still no service. Then we replace the antenna switch and RF IC, the problem still the same. It seems that colleagues have amplified the problem.

Now we use multimeter to measure the power supply on RF IC U_WTR_RF, we found that the resistance at both ends of the R38808_RF resistor on VDD_XO_2V power supply is incorrect, one side it 438, the other side is 564. U_WTR_RF and R38808_RF in the circuit diagram position as shown in 1-2 and 1-3. 

When we use multimeter Lead Probe to press it, it' s back to normal, so we can judge that the resistance is virtual welding. Now we find the problem, so we solder it with soldering station. After finish it, we assemble the iPhone and test it, the signal was back. As shown in picture 1-4.

Finally, we put the removed RF IC back in iPhone motherboard, as shown in picture 1-5. The repairs end here.