Manual on How to Choose and Use a Soldering Iron
A soldering iron is an indispensable tool for some advanced repairs on the motherboard. It is mainly used for soldering and de-soldering solder wire and electronic components to the PCB. A soldering iron is always attached with the soldering station so as to make soldering work much easier and faster. So if coincidently you have a soldering iron and intend to do some soldering work by yourself, then this manual is just what you need; It doesn’t matter if you don’t have one at present ,this manual also works. The next time when you decide to buy a soldering iron, try to keep the following rules in mind.
1. It must also be ESD-Safe (Antistatic) because most electronic components in a mobile phone are very sensitive and can get damaged due to static charge or static electricity.
2. Select the one that is easy to hold and does not burn you hand.
3. The soldering iron must have option to choose and select different types and shapes of soldering tips or bits. These tips or bits must be replaceable.
4. A 50 watt soldering iron is good enough for most mobile phone repairing job.
If you are still hesitating on which to choose after reading all those instructions, please visit our website for further help, it may give you a surprise.
Now let’s go on with our soldering work!
Step 1
Clean the points on the PCB you have to solder with the soldering iron itself and make them flat.
Step 2
Switch on the iron and keep it on for around 2 minutes to let it become very hot. If you are right-handed, hold the part which you have to solder with the left hand and solder it with the right hand. If the part you want to solder is minute or small, you will need to hold it with tweezers.
Step 3
Take some solder wire (as per your need) on the tip of the solder iron, put the part you want to solder and touch the point where you want solder it. When you see it stuck properly, leave the tip and do not move anything until the joint cools down and manually check it. If it’s not proper, repeat it until its stuck properly.
To most of us, it sounds as if soldering is an extremely difficult task which must carry out with the help of professional knowledge and skills. It is true, soldering do take time, patience as well as skillful operation, but it can be smoothly completed with your repeated practice.
1. It must also be ESD-Safe (Antistatic) because most electronic components in a mobile phone are very sensitive and can get damaged due to static charge or static electricity.
2. Select the one that is easy to hold and does not burn you hand.
3. The soldering iron must have option to choose and select different types and shapes of soldering tips or bits. These tips or bits must be replaceable.
4. A 50 watt soldering iron is good enough for most mobile phone repairing job.
If you are still hesitating on which to choose after reading all those instructions, please visit our website for further help, it may give you a surprise.
Now let’s go on with our soldering work!
Step 1
Clean the points on the PCB you have to solder with the soldering iron itself and make them flat.
Step 2
Switch on the iron and keep it on for around 2 minutes to let it become very hot. If you are right-handed, hold the part which you have to solder with the left hand and solder it with the right hand. If the part you want to solder is minute or small, you will need to hold it with tweezers.
Step 3
Take some solder wire (as per your need) on the tip of the solder iron, put the part you want to solder and touch the point where you want solder it. When you see it stuck properly, leave the tip and do not move anything until the joint cools down and manually check it. If it’s not proper, repeat it until its stuck properly.
To most of us, it sounds as if soldering is an extremely difficult task which must carry out with the help of professional knowledge and skills. It is true, soldering do take time, patience as well as skillful operation, but it can be smoothly completed with your repeated practice.
评论
发表评论