Repair iPhone 5 Not Charging
Has your iPhone been overcharged? Do you know what's going on? It is a very common problem that mobile phones can't charge. So why can't mobile phones charge in? What should be done after encountering such a situation? The following is the case that we successfully repaired the iPhone5 and cannot be charged.
The charging part of iPhone 5 is made up of Q2, U2 and U7. As shown in picture, the circuit diagram of the charging port J7 can be inquired on the WUXINJI dongle
The 5V voltage sent from the tail plug passes through the Q2 to send two 5V power supply. PP5V0_USB_PROTECT and PP5V0_USB_RPROT were sent to U7 and U2 respectively.
In addition, there are two detection pin in the middle of the battery contact J6! they pass through FL10, FL11 respectively and send to power IC-U7, FL10, FL11, in actual cell phone repair, it is found that the 2 pins are very easy to fall off, causing the cell phone can not be charged! and keep reboot again and again!
If there is a problem of charging, plug in the data cable, use Fluke digital multimeter to measure whether C304 has 5V output, and measure whether C272 has 5V output.
If not, you need to test the iPhone 5 charging port flex cable, short connect the Q2.
If both of them can be measured 5V, then the problem is in U2 or U7.
In addition, the battery detection pin problem will cause abnormal charging, the more charging, the less battery power will be, and also there will be automatic restart fault.
Need more iPhone repair knowledge,please visit www.vipfixphone.com.
The charging part of iPhone 5 is made up of Q2, U2 and U7. As shown in picture, the circuit diagram of the charging port J7 can be inquired on the WUXINJI dongle
The 5V voltage sent from the tail plug passes through the Q2 to send two 5V power supply. PP5V0_USB_PROTECT and PP5V0_USB_RPROT were sent to U7 and U2 respectively.
In addition, there are two detection pin in the middle of the battery contact J6! they pass through FL10, FL11 respectively and send to power IC-U7, FL10, FL11, in actual cell phone repair, it is found that the 2 pins are very easy to fall off, causing the cell phone can not be charged! and keep reboot again and again!
If there is a problem of charging, plug in the data cable, use Fluke digital multimeter to measure whether C304 has 5V output, and measure whether C272 has 5V output.
If not, you need to test the iPhone 5 charging port flex cable, short connect the Q2.
If both of them can be measured 5V, then the problem is in U2 or U7.
In addition, the battery detection pin problem will cause abnormal charging, the more charging, the less battery power will be, and also there will be automatic restart fault.
Need more iPhone repair knowledge,please visit www.vipfixphone.com.
评论
发表评论